Specifications

CHAPTER

4-1

Cisco Unity Express Voice-Mail and Auto-Attendant CLI Administrator Guide for 3.0 and Later Versions

OL-14010-09

Configuration Tasks

This chapter lists the tasks for configuring and maintaining Cisco Unity Express and contains the

following sections:

• Configuring the System Using CLI Commands, page 1

• Configuring the System Using the GUI, page 1

• Configuration Tasks, page 1

• Ongoing Tasks, page 10

• As-Needed Tasks, page 10

Configuring the System Using CLI Commands

If you will configure one or more Cisco Unity Express systems exclusively using CLI scripts, enter the

command environment as described in “Entering the Command Environment” on page 1. Proceed with

the scripts, using the sections in this chapter as a guideline for configuring the system components. When

entering the GUI for the first time and the initialization wizard appears, choose the skip option to avoid

reconfiguring the system.

Configuring the System Using the GUI

The Cisco Unity Express GUI provides the initialization wizard software tool to configure the basic

system parameters and import any subscribers configured on Cisco Unified Communications Manager

or Cisco Unified CME.

If you log in to the GUI web interface after installation, the initialization wizard is the first screen to

appear. You cannot activate it again except by reinstalling Cisco Unity Express software. All the

parameters configured through the initialization wizard are available through GUI screens and CLI

commands. See “Configuring the System for the First Time,” in the Cisco Unity Express GUI

Administrator Guide for more information about the initialization wizard.

Configuration Tasks

Table 4-1 lists the initial configuration tasks, the section describing each procedure, and additional

information needed for each task.