Service manual
Table Of Contents
6-3
HVR-MRC1
1-3. Installation of Driver
Install the driver exclusive for confirmation of HVR-MRC1.
Install the driver in the following procedures. Once this work is
performed, further installation is not required later on.
Note: If the PC restarts after the driver installation completes,
starts from the procedure No. 15.
1. Double-click “Port95nt.exe” in the Uploader folder.
2. According to the installation wizard, begin the installation.
3. After the installation completes, restart the PC.
4. After restarted, open “Control Panel” → “Add Hardware”, and
click “Next”.
Fig. 6-1-3
5. Select “Yes, I have already connected the hardware” and click
“Next’.
Fig. 6-1-4
6. Select “Add a new hardware device” and click “Next”.
Fig. 6-1-5
7. Select “Install the hardware that I manually selected from a
list” and click “Next”.
Fig. 6-1-6
8. Select “Show All Devices” and click “Next”.
Fig. 6-1-7