Service manual

6-7
HVR-MRC1
1-4. Reading of History Information
Note: The following shows a case that uses the batch file of En-
glish version.
For Japanese version, use “HISTORY.bat”.
Procedures
1. Double-click “HISTORY_E.bat” copied to the PC.
2. The command prompt starts up. Following the message, press
the [ENTER] key of PC.
Fig. 6-1-22
3. The Notepad will open automatically and display the history
information.
Fig. 6-1-23
4. Close the Notepad. The command prompt window will close
automatically.
5. The history information file “HISTORY.TXT” is created in
the same folder as HISTORY_E.bat, and accordingly you can
see the history information by opening the file with the text
editor, etc.
If you execute HISTORY_E.bat with the HISTORY.TXT al-
ready created, new history information will be added to the
HISTORY.TXT with previously read history information re-
mained unchanged.
1-5. Clearing of Error Code History
Note: The following shows a case that uses the batch file of En-
glish version.
For Japanese version, use “ERROR.bat”.
Procedures
1. Double-click “ERROR_E.bat” copied to the PC.
2. The command prompt starts up.
Fig. 6-1-24
•To execute, press the [ENTER] key of PC. The clearing of error
code history will be executed.
•To cancel, click “x” mark at the upper right of the command
prompt window to close the command prompt window.
3. When the clearing of error code history finished, the follow-
ing message will be displayed in the command prompt win-
dow.
Fig. 6-1-25
4. Press the [ENTER] key of PC to close the command prompt
window.