Owner`s manual

Page 16
Grounding Instructions (Illustration)
ELECTRICAL
CONNECTIONS
grounding method must comply with local electrical code
requirements; or in the absence of local codes, with the National
Electrical Code, ANSI/NFPA 70 or the Canadian Electrical Code,
CA C22.1.
See wiring diagram furnished with dryer. Your dryer is completely
wired at the factory and it is only necessary for the electrician to
connect the power leads to the wire connectors within the service
connection box on the rear of the dryer. Do not change wiring
without consulting factory as you may void the factory warranty. Do
not connect the dryer to any voltage or current other than that
specified on the dryer rating plate. (Wiring diagram is located on
rear wall of dryer.)
ELECTRICAL
CONTROLS SERVICING
Caution: Label all wires prior to disconnection when servicing
controls. Wiring errors can cause improper and dangerous operation.
Verify proper operation after servicing.
Attention. Lors des operations d’entretien des commandes,
etiqueter tous les fils avant de les deconnecter. Toute erreur
de cablage peut etre une source de danger et de panne.