User's Manual

CONTENTS LIST AND PARTS IDENTIFICATION
1. 6.
Add SD Card
To record a movie, press the Select button (check mark). The red dot in the upper right
corner of the screen will begin to flash on and off and a timer will appear that shows the
duration of the movie. To stop the recording, press the Back button (up-arrow).
You can also instantly start a recording by pressing the large round button on top of the
camera.
REVIEW – When you choose this screen option and press the check mark button, you will
be given the choice of reviewing any photos or movies you have taken. The SD memory
card containing the photos or movies must be inserted in the viewer to use this function.
Once you choose to review either photos or movies you will be shown a list of the items
stored on the SD memory card. Move the cursor with the down-arrow button. Press the
check mark button to choose which item you wish to review. Press the up-arrow button to
return to the item choice menu. Press the up-arrow again to return to the main screen menu.
TIMER – Use the Next button (down-arrow) to choose the timer function, then press the
Select button (check-mark). A timer display is shown and you are given the choice of adding
time or confirming your choice (OK). The timer display will increase by one minute every
time you choose to “Add Time”, up to a maximum of 5 minutes. If you continue pushing the
Select button the timer display will return to “00:01” (one minute). Choosing “OK” will start
the countdown to “00:00.” Movie recording will then start, and will continue for 90 seconds.
The timer will then begin the countdown again, using the preselected time. Another 90
second movie will be recorded. This will continue until the user-installed SD memory card is
full. The number of movies you can record and save will depend on the memory capacity of
the SD card you are using.
DELETE – Choosing this function and pressing the check-mark button lets you delete any
photo or movie by choosing it and then pressing the check-mark button. You will be asked
to confirm your choice by pressing the check-mark button again. Choices are also available
to delete all photos or all movies at once.
Some function screens will show a battery icon in the upper left hand corner of the screen.
As battery power is used the bars that make up the battery icon will disappear one by one.
When the lithium-polymer battery needs to be recharged a “Battery Low” icon will briefly
appear and the battery icon will turn red and flash on and off several times.
Attach the USB cord and connect the viewer to a computer’s USB port as described in the
above section “GETTING STARTED.”
VIEWER BATTERY RECHARGING
The EyeSpy™ EAGLE SPY is an amazing radio-controlled,
camera-equipped helicopter enabling you to see the world just as if
you were sitting in the cockpit!
Landing Skid
Tail
Rotor
Stabilizer
Rotor Blade
Rotor Blade
Rotor Blade
Camera
AC Adapter
USB Cable
Viewer
Controller
Antenna
GETTING STARTED
Controller:
Use a small Philips head (+) screwdriver to remove
the battery compartment cover located on the back
of the controller. Insert six AA 1.5V alkaline batter-
ies, taking care to insert them correctly, using the
images molded into the plastic of each battery
location. Reinsert the battery cover and retighten the
two chromed screws. Do not use inexpensive
carbon-zinc batteries, generally labeled “heavy-
duty.”
1.
Add
Batteries
BATTERY SAFETY INFORMATION
• This unit uses six AA 1.5V batteries. Always use fresh batteries.
• Do not mix old and new batteries. Do not mix batteries of different types.
• Remove exhausted batteries and dispose of them properly.
• If this item will not be used for an extended term please remove the batteries.
• Do not try to recharge a non-rechargeable battery.
• Do not take a battery apart. Do not short-circuit the terminals.
• Do not dispose of batteries in fire – they may explode.