User's Guide


Fix with tape.
The printer stopped with the paper partially cut
1
Set the ON/OFF switch to OFF and then ON again.
The paper jam is released and the cutter blade returns to
its standby position.
2
Remove the partially printed part of paper from the printer.
1H[WUHIHUWR³7KHSULQWHULVMDPPHGZLWKSDSHU´VHH3
The power has been cut during printing
,IWKHSRZHULVFXWGXULQJSULQWLQJ\RXZLOOQRWEHDEOHWRRSHQWKHWRSGRRU
1
Set the ON/OFF switch to OFF and then ON again.
The partially printed paper is cut into scrap-size pieces and removed.
After this, you can open the top door.
2
Check that no partially printed paper remains in the printer.
,ISDUWLDOO\SULQWHGSDSHUUHPDLQVUHIHUWR³7KHSULQWHULVMDPPHGZLWKSDSHU´VHH3
Caution
 ,IWKHSDSHUMDPLVQRWUHOHDVHGGRQRWIRUFHIXOO\SXOORXWRUWHDURႇWKHSDSHU
&RQWDFWDVHUYLFHUHSUHVHQWDWLYH3XOOLQJWKHSDSHUZLWKIRUFHPD\GDPDJHWKHFXWWHU
Caution
 6HWWKHSULQWHUXQLW¶V212))VZLWFKWR21EHIRUHVHWWLQJWKHSDSHUDJDLQ
:KHQWKHWUDVKER[LVFORVHGWKHSULQWHUXQLWSHUIRUPVSDSHULQLWLDOL]DWLRQ
$Q\PDWWHUSULQWHGZKHQWKHHUURURFFXUUHGZLOOEHRXWSXW
7KHHUURULVQRWFOHDUHGXQWLOLQLWLDOL]DWLRQLVSHUIRUPHG
Caution
 'RQRWVHWWKH212))VZLWFKWR2))GXULQJSULQWLQJ7KLVPD\FDXVHDPDOIXQFWLRQ
Caution
 'RQRWUHPRYHWKHWUDVKER[DWWKLVWLPH7KLVPD\FDXVHDSDSHUMDP
7URXEOHVKRRWLQJ
Work was continued while the printer unit’s ON/OFF switch is OFF
4
Reattach the ribbon with tape or similar
material.
5
Rotate the take-up roller until the part
attached with tape cannot be seen
anymore.
6
Insert the ribbon in the printer unit.
7
Close the printer unit’s top door.