Dot Matrix Printer CD-S500 Series User's Manual

38
Chapter4
Maintenance Mode
Soft SW Setting Mode
Buffer Size 4k 40byte
4Kbyte
Init Signal ENB ENB
DIS
Buzzer ON ON
OFF
Baud Rate 19200 19200
9600
4800
2400
1200
Data Length 8 bit 8 bit
7 bit
Parity Bit NONE NONE
EVEN
ODD
Stop Bit 1 bit 1 bit
2 bit
Protocol DTR DTR
X-ON-OFF
Paper Width 76.2 76.2
69.5
57.5
Set item Initial value Setting value Remarks
Set item Initial value Setting value Remarks
Set item Initial value Setting value Remarks
The receiving buffer size is selected.
Selects buzzer sound when an abnormality occurs as
enabled (ON)/disabled (OFF).
Sets the baud rate of the serial interface.
Sets the character length of the serial interface.
Sets the communication parity of the serial interface.
Sets the stop bit of the serial interface.
Selects the paper size.
Selects enabled (ENB)/disabled (DIS) of the printer
initialized signal (PRIME) during centro-interface.
Selects enabled (ENB)/disabled (DIS) of the 25pin reset
signal during serial interface.
 Mechanical-SW
 Interface-SW (Displayed only when the serial board is mounted)
Auto-Cutter FREE OFF
FREE
FULL
PAR.
Selects the cutter operation.
When it is OFF, the FULL/PAR. commands do not start
cutting.
In FREE status, cutting is done according to the
FULL/PAR. commands.
In FULL status, full cut is always done by both the
FULL/PAR. commands.
In PAR status, partial cutting is always done by both the
FULL/PAR. commands.