Dot Matrix Printer CD-S500 Series User's Manual

39
Initial Factory Shipping Mode
Setting the mode
1.Pressing the FEED switch twice in
maintenance mode (POWER LED is
flashing) causes the POWER LED, PAPER
OUT LED, and the ERROR LED to begin
to flash.
2.Reopening and closing the front cover in
this status switches the POWER LED,
PAPER OUT LED, and the ERROR LED
from flashing to continuously lit status.
3. Pressing the FEED switch for 3 seconds or
more restores settings to the factory
shipping (initialized) status.
Flashin
g
Press twice
Reopening and closing the front cover:
Flashing Lit
Maintenance Mode
Concerning Mechanical-SW operation
Functions that are not supported by the specifications at time of shipping have no
impact on printer operation even when the settings are changed.
Examples) Items set for the Auto-Cutter in models that are not equipped with an
Auto-Cutter.
Change of the setting of the Take-Up Device in models to which rewinder
specifications do not apply.
Color Ribbon ON ON
OFF
Take-Up Device ON ON
Set item Initial value Setting value Remarks
Selects the color function.
During OFF, the change color command is ignored.
Selects the rewinder function.
During OFF, the rewinder motor does not operate.
Concerning Auto-Cutter operation
The minimum cutting interval is 1/2 inch (3 lines with 6LPI).
Once a cut command has been executed, even if a command is sent before the paper
has fed at least 1/2 inch, the cut command is ignored so the cut action cannot be
executed.