Printer iDP-460 User's Manual

iDP-460 User’s Manual
40 CITIZEN
8. DRAWER KICK-OUT CONNECTOR AND POWER CONNECTOR
8.1 Specifications of Drawer Kick-Out Connector (D-type Only)
(1) Drawer kick-out drive signal
The pulses specified by the BELL command(07h) are output.(Approx. 200 ms)
(2) Electrical characteristics
1) Drive voltage: 24 V DC
2) Drive current: 0.8 A at maximum
8.1.1 Connector’s Pin Configuration
No. Signal Function
1 FG Frame Ground
2 DRAWER Drawer drive signal
3
4 VDR Drawer drive power
5
6 GND Common ground on the circuit
Connector used : TM5RJ3-66(HIROSE) or equivalent
Applicable connector : TM3P-66P(HIROSE) or equivalent
CAUTION : • No output is made while printing.
• A solenoid used for the drawer should be of 36 Ω or more. An output
current should be kept below 0.8 A. Otherwise, there is a danger of
trouble or burnout.
• This connector cannot be connected to a telephone line. Do not connect
other than the solenoid.
8.1.2 Drive Circuit