Instruction manual

24
25
Manual reception updating may be attempted
at anytime. However results will vary based on
location, time of day, weather, etc.
0 1 2
Button (A)
• The watch will not start to receive if the second
hand is moving once every two seconds (this is the
insufficient charge warning). Fully charge the watch
before attempting on-demand reception.
• Not all areas can receive a signal. Be sure you are not
in such an area and confirm the city is selected for
your time zone.
→
pages 16 and 17
1. Push the crown in to position
0
.
2. Press and hold the lower right button (A)
for 2 seconds or more, then release.
The second hand points to RX, a tone will
sound, and the watch enters radio reception
mode. As soon as the reception level is
identified, the second hand points to either H,
M, or L.
→
Refer to the next page.
When the reception has finished, a tone sounds, and the second hand
restores the normal operation.
• It will take 2 to 15 minutes to finish reception.
■
To cancel manual reception updating
Press and hold the lower right button (A) for 2 seconds or more, then release.
This cancels manual reception updating and the watch resumes normal operation.
●
Second hand positions and reception results
RX: Reception
in progress
L: Radio reception updating
was successful with low
signal strength.
M: Radio reception updating was
successful with medium signal strength.
H: Radio reception updating was
successful with high signal strength.
On-demand reception—manual signal reception activation
On-demand reception—manual signal reception activation
Modes supporting this function:
[LAX] [DEN] [CHI] [NYC] [LON]