Instruction manual

32
33
The chronograph is able to measure time up to 59 minutes 59 seconds in
1-second units. It is reset to 0 after reaching 59 minutes 59 seconds.
1. Pull the crown out to position
1
.
2. Rotate the crown to align the mode
hand to the CHR (chronograph)
position.
3. Return the crown to position
0
.
The second hand and function hand
move to the 0 position respectively.
• The second hand changes to the
chronograph second hand and
moves in 1-second steps after a time
measurement is started.
• The function hand (2:00 sub dial)
changes to the chronograph minute
hand and moves in 1-minute steps after
a time measurement is started.
0 1 2
Function hand
Second hand
■
Starting time measurement
Press and release the upper right button (B).
The chronograph starts measurement.
• The chronograph stops and starts whenever you
press and release the upper right button (B).
• Pulling the crown out during chronograph
operation will stop and reset the chronograph.
■
Resetting the chronograph
While the chronograph is stopped, press
and release the lower right button (A).
The chronograph resets to 0 minute 0 second.
• During measurement, the chronograph will not be
reset even if you press the button (A).
0 1 2
Button (A)
Button (B)
• Radio signal cannot be received in the chronograph mode.
• After you have completed chronograph use, be sure to reset your watch to one
of the time modes.
→
pages 16 to 17, or 26 to 27
Using the chronograph function
Using the chronograph function
Modes supporting this function:
[CHR]
Mode
hand