Instruction manual

5454
5555
If the watch operation is unstable due to strong impact or static electricity, or
other malfunction occurs, you will need to set the watch to default settings.
• Resetting the watch causes all customized settings and data to be cleared.
• Be sure to charge the watch fully before resetting it.
→
page 39
• If you reset the watch while the charge level is insufficient, the watch remains
stopped. In this case, charge the watch and then perform the subsequent
operations.
→
page 39
• After resetting, make sure to check and correct the reference positions.
→
pages 46 to 49
Once reset, the watch settings are changed as follows.
• Date : January 1st (leap year)
• Time : 0 hour, 0 minute, 0 second in London
• Daytime savings time : OFF (automatic changeover) for all city settings
0 1 2
Button (B)
Button (A)
1. Pull the crown out to position
1
.
2.
Rotate the crown to align the mode hand to [CHR].
The second hand moves to the 0 second position and
the hour and minute hands move slightly. The settings
are reset to the defaults.
3. Pull the crown out to position
2
.
4. Press the buttons (A) and (B)
simultaneously and release them.
The second hand moves to the 0 second position and the hour and
minute hands move slightly. The settings are reset to the defaults.
Resetting the watch to the default settings
After resetting, always perform the following operations.
1. Correct the reference (0) positions.
→
pages 46 to 49
2. Select a city.
→
pages 16 and 17
3. Correct the time and date.
• Correct by manually receiving radio signal
→
pages 24 and 25
* In the alternate time (A-TM) mode, radio signal cannot be received.
• Manually correct
→
pages 42 to 45
Resetting the watch to the default settings
Modes supporting this function:
[CHR]