Setting Guide

20
21
English
5.
Press and release the lower right button Ⓐ to reset the measured time.
• Makesuretoresetthetimeafterfinishingmeasurement.
6.
Press and release the lower right button Ⓐ again to return to current time
indication.
• Thecurrenttimeindicationwillresumeautomaticallywhenleavingthewatchfor
approx. 3 hours.
• When 30 seconds have elapsed after the measurement is started (or restarted), the
chronograph 1/20 second hand stops at the zero second position. However, the
measurement is still conducted.
• The chronograph cannot be used when the power reserve is at level 0. Even when
the power reserve is at level 1, we recommend charging the watch before using
the chronograph.
• Do not pull out the crown during chronograph measurement operation. The
measurement will stop.
Using the chronograph
1.
Ensure that the crown is in position 0
.
2.
Press and release the upper right button Ⓑ .
The watch enters the chronograph mode.
• Asshowninthefigure,thechronograph
minute, chronograph second, and chronograph
1/20 second hands point in the 12 o’clock
direction.
3.
Press and release the upper right button Ⓑ
to start measurement.
4.
Press and release the upper right button Ⓑ
to suspend measurement.
• Pressingtheupperrightbutton
Ⓑ
again will
resume the measurement operation.
Using the chronograph
󱠄
Ⓑ
0 1 2
60
30
1050
2040
ON
SMT
OFF
S
OK
RX
NO
M
T
W
T
F
S
00
50
10
20
30
80
90
4060
70
The chronograph can measure up to 60 minutes in units of 1/20 seconds.
Chronograph
minute hand
Chronograph 1/20
second hand
Chronograph
second hand