Setting Guide
Table Of Contents
- Safety precautions (IMPORTANT)
- Before using this watch
- Table of contents
- Features
- Component identification
- Charging your watch
- Using the chronograph
- Setting the World Time
- Setting Daylight Saving Time
- Notes on the time signal reception
- Checking the time signal reception
- Receiving the time signal manually (On demand reception)
- Adjusting the time/calendar manually
- Checking and correcting the current reference position
- Troubleshooting
- Eco-Drive (solar powered) watch handling precautions
- Water resistance
- Precautionary items and usage limitations
- Specifications
58
59
English
TroubleshootingTroubleshooting
1.
Correct the reference position.
See page 51.
2.
Set the city.
See page 22.
• TosetDaylightSavingTime,seepage 27.
3.
Set the time.
To adjust the time by receiving the time signal, see page 43. To adjust the time
manually, see page 45.
◆ All Reset
When the watch does not work properly, you can reset all the settings. If the
power reserve is insufficient, fully charge the watch as outlined on page 15.
Check before performing All Reset.
After performing All Reset, you will need to configure all settings.
Completely set the watch by following the procedures outlined below:
◆ Performing the All Reset
Perform this operation after checking the contents of the previous page in this
manual.
1.
Pull the crown out to position .
2.
Press and hold both the lower right button Ⓐ and the
upper right button Ⓑ for four or more seconds.
AllResetwillbeperformed.
The settings will be reset as follows:
Ⓑ
Ⓑ
0 1 2
The settings after All Reset
•
Reference positions of hands/date
: Positions when the
crown is pushed in.
•
Calendar :
Leap year, January/Sunday
•
City :
LON (London)
•
Daylight Saving Time :
OFF (Standard time)
•
Switching of Daylight Saving Time
:
Auto