Setting Guide

10 11
Helpful Hint for Accurately Setting the Time:
After stopping the second hand at the 0 seconds position, advance the minute and hour
hands 4-5 minutes past the correct time and then move them back to the correct time.
Setting the time in this manner eliminates any play in the gears of the watch movement.
The hands of the watch can be made to advance at the correct time by pushing in the crown
in synchronization with a telephone time signal or other time signal.
[Procedure for Setting the Date]
• This watch is not equipped with a fully
automated calendar. It is necessary to correct
the date by operating the crown to the first day
of the following month in those months with
less than 31 days (months having 30 days and
February). (The date is displayed based on a
31 day cycle.)
1. Pull the crown out to the date correction position (first click).
2. Set the date by turning the crown to the left. If the crown is turned to the right, nothing
will happen and the date will not change.
• Do not attempt to set the date between the hours of around 9:00 PM and 1:00 AM. If
the date is set during this time period, the date may not change on the following day.
3. Once the date has finished being set, return the crown to the normal position (0 position).
* The date will change automatically at around 12:00 AM. If the date changes at 12:00
PM, advance the time by 12 hours.
7
60
39
12
ON
OFF
500
400
300
250
120
130
140
150
160
180
200
220
80
85
90
95
100
110
65
70
75
T
A
C
H
Y
M
E
T
E
R
60
CHARGE
45 15
Normal
position (0)
Date correction
position (1)
Date
12 13
6. Using the Chronograph
• The chronograph is capable of timing and displaying the time for up to 12 hours in 1/5
second units. The chronograph stops automatically when 12 hours have elapsed.
• When starting timing, first check that each of the chronograph hands has returned to
12:00 . If the hands are not at 12:00, press button (B) to return them.
• The force required to press button (A) is slightly greater when starting timing for the first
time to indicate that chronograph timing has begun. Firmly press button (A) until a
clicking sound is heard.
[Timing Procedure]
1. Press button (A) when the watch
is in the chronograph reset state
to start timing. Press button (A)
again to stop timing.
•Timing starts and stops
repeatedly each time button
(A) is pressed.
[Chronograph Reset State]
[Note]
• When pressing button (A), be careful not to also
press the alarm crown at the same time. This is
particularly important in the case of models in which
the crown is located at the 12:00 position.
Be careful not to press the
alarm crown
Button (A)
7
60
3
9
12
ON
O
FF
500
400
300
250
120
130
140
150
160
180
200
220
80
85
90
95
100
110
65
70
75
T
A
T
T
C
H
Y
M
E
T
E
R
60
C
HAR
G
E
45
15
Chronograph second hand
Chronograph
hour hand
Chronograph
minute hand
Button (A)
Button (B)
Chronograph
scale