Instruction manual

On rare occasions, even if the water sensor senses traces of water and the
watch is switched to the dive mode (dive ready state), however, log (I) display
may fail to change to log (II) display automatically.
In case this happens, press button A to change the display.
29
Button A
Button A
• Only when log (I) is displayed, the display is automatically changed to log (II)
after 2 seconds without pressing button A.
28
• Each time button A is pressed, the log display is changed to the next in the
order of (I), (II), (III) and (IV).
Changing the Log Display
Every dive makes the watch memorize the following 8 types of log data auto-
matically, which can be recalled in the order of (I), (II), (III) and (IV) as shown
below.
• When the watch is switched from the chronograph mode to the log mode by
pressing button M, log (I) is displayed.
Log (I) Log (II)
Button A
Number of
dive times
Month and
date
Button A
or
AUTOSWITCH
after 2 seconds
Max. depth
Dive time
➡
A
➡➡
A
➡
A
A
Dive start time
Dive end time
Log (III)
Average depth
Lowest temp.
Log (IV)