Instruction manual

3) Press button B to switch to the number of times of alarm occurrences
correcting mode (the preset number of times starts flashing).
4) Change and set the number of times of alarm occurrences by pressing
button A.
The display for the alarm frequency is changed and cycled in the following
order: ON → OFF →1 → 2 → 3 → 4 → 5.
ON: The depth alarm will beep every minute when the diving depth is deeper
than the set depth.
OFF: Depth alarm is disabled.
5) Press button B to switch the dive time alarm display to the correcting mode
(the preset value for the dive time alarm starts flashing).
6) Change and set the dive time alarm time by pressing button A.
The display for dive time alarm is changed and cycled in the following order:
— — → 05 →10 →15 ....... → 95 → — —.
* With the display of “— —”, the dive time alarm is disabled.
7) Press button B or M to finish the setting procedure.
Dive Alarm Monitor
By keeping button A depressed, repetitive alarm monitoring at 4 second
intervals can be performed in the following order: depth alarm → dive time
alarm → rapid ascent warning alarm.
37
Setting the depth alarm/dive time alarm
1) Press button B for 2 seconds or more
to switch to the DIVE ALARM correcting
mode (the preset depth value starts
flashing). At this time, the digital display
(II) changes from the dive time alarm
display to the display for the number of
times the alarm will be activated.
2) Set a diving depth at which you want the
alarm to sound by pressing button A.
Each time button A is pressed, the
depth setting becomes deeper by 1 m
94 ft). A maximum setting is 80 m
(260 ft). With the maximum exceeded,
the setting is returned to 1 m (4 ft).
* Rapid advance of settings is made by
pressing and holding down the button
A.
36
Depth alarm
Dive time alarm
Button B
Button M
Button A
CA
MAX
SEL
SP
P
A
STA
RES
SET
DIV
STP
SEL