Instruction manual

2. Dive Time Measurement
When the diving depth reaches to 1.0 m (4 ft), the
dive time measurement will start. It stops when
the depth becomes less than 1.0 m (4 ft).
If the diving depth becomes deeper than 1.0 m
(4 ft) within 10 minutes after the end of the dive
time, the dive time resumes at the time when the
measurement is stopped and the accumulative
time is recorded successively.
3. Water Temperature Measurement
Water temperature measurement starts 1 minute
after a depth of 1.0 m (4 ft) is measured and
displayed. Subsequently, temperatures will be
measured every minute.
Units of water temperature measurement: 0.1°C
(1°F)
Range of measurement: -5.0°C to +40°C
(23°F~104°F)
Before temperature measurement and out of the
measurement range: the display will be – –.–°C
(– – – °F)
* While button A stays depressed during the dis-
play of the diving time, the display shows water
temperature readings, not the diving time.
41
Dive time measurement
40
Depth Measurement Readings
1. Depth Measurement
The diving depth is measured every second, and
the reading of the depth is displayed on the watch.
Units of depth measurement: 0.1 m (1 ft)
Range of measurement: 1.0m to 80.0 m (4 ft to
260 ft)
When diving depth is less than 1 m (4 ft): the
display will be 00.0 m (000 ft).
When diving depth exceeds 80 m/260 ft: display
will be – –.– m (– – – ft).
In case the ER (Error) displayed depth
reading flashes;
This means that the depth measurement is faulty.
Depth
Depth measurement
DIV
DIV
DIV
DIV
DIV
DIV
DIV
DIV
0m
1m
25.5m
80.0m
SEL
RES
SET
STP
SEL CA
0m
1m
SEL
RES
SET
STP
SEL CA
SEL
RES
SET
STP
SEL CA
SEL
RES
SET
STP
SEL CA
SEL
RES
SET
STP
SEL CA
SEL
RES
SET
STP
SEL CA
Depth
Within
10 minutes
Stop
Start Start