Specifications

14. USING THE ALARM

The alarm setting procedure and other procedures for alarm use are the same for

Alarm 1 and 2. Only the tone that sounds is different.

The alarm sounds for 15 seconds when the set time is reached once a day. When the

alarm is sounding, it can be turned off by pressing button (A) or (B).

4. When button (A) is pressed, the location to be corrected changes each time it

is pressed. Select the location to be corrected so that it flashes.

a. The alarm can be set (ON) or canceled (OF) by pressing button (B) when

the watch is in the alarm ON/OF correction state.

b. When the crown is turned forward (clockwise) in the "hours" or

"minutes" correction state, correction is made in the positive

direction. When the crown is turned backward (counter-clockwise),

correction is made in the negative direction.

c. Turning the crown continuously allows corrections to be made rapidly.

5. After corrections have been completed, return the crown to the normal

position.

Note:

When the time mode is set to the 12-hour time display, the alarm time also uses a

12-hour time display. Pay attention to AM and PM when setting the alarm time.

1. The alarm can be switched ON and OF by pulling out the crown to the first

click when the alarm mode is on

2. Pressing button (B) switches the alarm ON and OF each time it is pressed

3. Return the crown the normal position after the alarm has been set to ON or

OF.

1. Pressing buttons (A) and (B) simultaneously during the normal alarm display

causes the alarm to sound for confirmation for as long as they are pressed.

1. Turn the crown and set the mode hand to

either the Alarm 1 or 2 [AL-1] or [AL-2]

mode.

2. Press either button (A) or button (B) to

access the city to be corrected.

3. When the crown is pulled out to the second

click (alarm time setting position), the

watch enters the alarm correction state.

12:00

NYC

Return to Table of Contents