Specifications

II Parameters
Base Specifications Parameters
II - 9
【#1044(PR)】 auxno
Not used. Set to "0".
【#1060】 SETUP Activate setup processing
Execute the functions required for initializing the system.
(Note) Most setup parameters will be initialized with one-touch setup. So confirm the data
before executing.
This parameter will automatically be set to 0 when the power is turned ON.
【#1061(PR)】 intabs Manual ABS updating
Select whether to update the absolute position data during automatic handle interrupt.
This parameter is enabled only when "#1145 l_abs" is set to “1”.
0: Do not update (coordinate system shifted the amount of the interruption)
1: Update (same coordinates as when interrupt did not occur will be applied)
【#1062】 T_cmp Tool compensation function
Select whether the tool length compensation and wear compensation are enabled during T
command execution.
0 : Tool length compensation enable Wear compensation enable
1 : Tool length compensation enable Wear compensation disable
2 : Tool length compensation disable Wear compensation enable
3 : Tool length compensation disable Wear compensation disable
【#1063】 mandog Manual dog-type
Select the manual reference position return method for the second return (after the
coordinate system is established) and later.
The initial reference position return after the power ON is performed with dog-type return,
and the coordinate system will be established.
(This setting is not required when the absolute position detection is used.)
0: High speed return
1: Dog-type
【#1064(PR)】 svof Error correction
Select whether to correct the error when the servo is OFF.
0: Not correct the error
1: Correct the error
【#1065】 JOG_H JOG response type
Set the JOG responsiveness type.
0: Conventional specification
JOG is started or stopped by a signal via ladder without reference to an external
signal input.
1: Type 1
JOG is started or stopped by an external signal.
2: Type 2
JOG is started or stopped by logical AND of an external signal and a signal via
ladder.
3: Type 3
JOG is started when a signal via ladder rises. It is stopped when an external signal
and a signal via ladder fall.
4: Type 4
Reference position return mode:
JOG is started or stopped by a signal via ladder without reference to an external
input signal (conventional specification).
Non-reference position return mode:
JOG is started or stopped by logical AND of an external signal and a signal via
ladder (type 2).
---Setting range---
0 to 4
Y N
Y N
INPUT
1:Execute one-touch setup
#(1060) Data ( 1) ( )
"Standard parameter setting? (Y/N)" is displayed
To initialize the parameters To retain the current parameters
The parameter are initialized according to
the setting value in #1001VQ#1043
"Format? (Y/N)" is displayed
To initialize the machining program file
and tool offset file
To retain the current machining program
file and tool offset file
The above files are initialized and the standard
fixed cycle program is input
"Setup complete" is displayed
INPUT
INPUT
INPUT
INPUT