Instruction manual

9. Using the Chronograph Mode

The chronograph function provided with this watch is able to measure elapsed

time in 1/100 second units up to a maximum of 23 hours, 59 minutes and 59

seconds. After 24 hours have elapsed, the chronograph returns to the reset

display (0:00’00”00) and stops.

A. Setting the Alarm Time

(1) Press button (M) to switch to the alarm mode.

(2) Press button (B) for at least two seconds. The “hours” flash.

(3) Press button (A) to set the “hours”. (Pressing button (A) continuously caus-

es the characters to advance rapidly.)

(4) Press button (B). The “minutes” flash.

(5) Press button (A) to set the “minutes”.

(6) Press button (M) to return the watch to the normal display.

* If none of the buttons are pressed for about 3 minutes when the display is

flashing, the watch automatically returns to the normal display.

* Pressing button (M) when the display is flashing immediately returns the

watch to the normal display.

* If none of the buttons are pressed for about 3 minutes when in the alarm

mode, the watch automatically returns to the time/calendar mode.

The alarm tone can be monitored by pressing button (A) in the alarm mode.

The alarm tone can be heard for as long as button (A) is pressed.

CHR

(A)

(B)

(M)

*1: The chronograph automatically returns to

the measurement mode after 10 seconds.

Measurement

Stop

Split time

Hours, minutes

Seconds, 1/100 seconds

[Chronograph Reset Display]