Calibre 8700 Series (mvt. cal.
Calibre 8700 Series (mvt. cal.
MODELS – BL80** Calibre 8700 Series Mvt. Cal. No. E870 FEATURES BENEFITS Light Powered Environmentally Clean Energy Source Time Displays 12/24 Systems Perpetual Calendar Accurate to the year 2100 Alarm Daily Alarm Dual Time Second time zone IMPORTANT NOTE: If you suspect a malfunction, first check the 0-position of the hands as outlined in the 0-positioning check procedure. If the hands and date do not move to their respective 0positions, it will be necessary to set them for proper operation.
Setting Instructions for BL80** Calibre 8700 Series Cal. No. E870 ZERO-POSITION CHECK PROCEDURE 1.) If your timepiece malfunctions in some way or completely looses power, it will be necessary to first check the Zero Position of the hands. 2.) To begin, pull the crown out one ‘click’. 3.) Next turn the crown clockwise or counterclockwise, so that either tip of the Mode hand, is pointing to the L-TM, or Local Time mode. 4.) Now push the crown one ‘click’, back to the closed position next to the case. 5.
ALL RESET and 0-POSITIONING CORRECTION PROCEDURE 1) First, pull the crown out one ‘click’. 2) Next turn the crown clockwise or counterclockwise so that either tip of the Mode hand is pointing to LTM or Local Time mode. 3) Push the crown in one ‘click’ to the closed position. 4) When the hands have stopped moving, pull the crown out two ‘clicks’. 5) Press and hold the upper right and lower right buttons simultaneously for two to three seconds, then release.
5.) Be sure to set time to the correct AM/PM. by referring to the 24 hour hand. (AM time is indicated when the 24 hour hand points between 24 to 12. PM time is indicated when the 24 hour hand points between12 to 24) 6.) After setting time, push the crown in two ‘clicks’ to the closed position to finalize time setting. This completes the setting the time. SETTING THE CALENDAR 1) To begin pull the crown out one ‘click’.
3.) Turn the crown clockwise or counterclockwise to move the mode hand so that either tip is pointing to ‘ALM’ or Alarm Mode. The Hour, Minute and 24 Hour hands will move to the current alarm time set in memory. 4.) Now pull the crown out one additional ‘click’ to the Alarm time setting position. The alarm will automatically be activated and the Function hand will move to indicate ‘ON’. 5.) Rotate the crown either clockwise or counterclockwise to set the desired alarm time.
SETING THE LOCAL TIME 1) The L-TM or local time function allows the time to be set and displayed for a different time zone other than your own. It can be set in 1-hour increments only. 2) To begin, pull the crown out one ‘click’. 3) Now turn your crown clockwise or counterclockwise so that either tip of the Mode hand is pointing to ‘L-TM’ or Local Time mode. 4) Pull the crown out an additional ‘click’ to the Local time setting position.
