Service manual

CBM-270 Service Manual
10 CITIZEN
6. Detaching the NPE Sensor Unit
(1) Remove one M3
´
10 (BT) screw used to secure the NPE sensor unit.
(2) Pull out a cable.
7. Detaching the Operation Panel Board
(1) Remove two M2.6
´
8 (BT) screws. Turn over the upper cover and unscrew the operation
panel board.
(2) Detach the operation panel board.
8. Detaching the Printer Mechanism
(1) Remove four M2.6
´
8 (BT) screws used to secure the printer mechanism. Remove two
screws each from the front and back.
(2) Pull out the printer mechanism. Pull it out gently to the paper holder side (front) without
pulling a cable. If the label sensor is attached, separate it from the printer mechanism.