User Manual

ManualsBrandsCITIZEN ManualsHardwareCL-E331 label printer - B/W - direct thermal / thermal transfer

Table Of Contents

WEEE MARK
Compliance Statement for European Users
GENERAL PRECAUTIONS
SAFETY PRECAUTIONS...WHICH SHOULD BE STRICTLY OBSERVED
Warnings
General Precautions
Installation Precautions
PRECAUTIONS IN HANDLING THE PRINTER
THE TABLE OF CONTENTS
1. GENERAL OUTLINE
- 1.1 Features
- 1.2 Unpacking
- 1.3 Model Classification
2. Part Names and Function
- 2.1 Front of Printer
- 2.2 Operation panel
- 2.3 FEED Key Operation
- 2.4 Rear of Printer
- 2.5 Inside of Printer
3. SETUP
- 3.1 Printing Preparation Process
- 3.2 Loading Paper
- 3.3 Loading a Ribbon
- 3.4 Adjusting Media Sensor Positions
- 3.5 Connecting the AC Adapter
- 3.6 Connecting the Printer to a Host Computer
- 3.7 Install the Printer Driver
4. Configuring Printer Settings Using the Specialized Utility
- 4.1 List of Settings
- 4.2 Obtaining the LabelPrinterUtility
- 4.3 Using the LabelPrinterUtility
5. Configuring Ethernet Network Settings Using Network Seeker
- 5.1 Starting Network Seeker
- 5.2 Changing Settings
6. Configuring Printer Settings Using a Browser
- 6.1 LinkServer user roles
- 6.2 LinkServer menu configuration
- 6.3 LinkServer connection procedure
7. Configuring the Printer Using the Operation Panel
- 7.1 Sensor Adjustment Mode
- 7.2 Test print mode
- 7.3 Configuration Print Mode
- 7.4 Emulation switching mode
- 7.5 HEX Dump Mode
- 7.6 Initialization Mode
8. Online Configuration Mode
9. Clearing Jobs Stored in the Printer
10. Maintenance
- 10.1 Plastic Surface of Printer and Platen
- 10.2 Thermal head
11. Appendices
- 11.1 Troubleshooting
- 11.2 Basic Specifications
- 11.3 Usage Conditions
- 11.4 Storage Conditions
- 11.5 Interfaces

——

Adjusting the Left/Right Balance of the Ribbon

If the left/right balance of the ribbon needs to be adjusted, adjust it by moving the

ribbon left/right balance adjustment knob.

If wrinkles are occurring in the ribbon, make the adjustment described in the following

procedure.

Ribbon

Initial setting

position

Ribbon left/right balance

adjustment knob

1. Check on which of the left and right sides that slack occurs when looking from the

front of the ribbon.

CAUTION

If this cannot be determined easily when the ribbon is in a stationary state, perform printing and

check the part where the wrinkles actually occur.

2. Loosen the screw xing the ribbon left/right balance adjustment knob.

Screw

Ribbon