User Manual
Table Of Contents
- WEEE MARK
- Compliance Statement for European Users
- GENERAL PRECAUTIONS
- SAFETY PRECAUTIONS...WHICH SHOULD BE STRICTLY OBSERVED
- Warnings
- General Precautions
- Installation Precautions
- PRECAUTIONS IN HANDLING THE PRINTER
- THE TABLE OF CONTENTS
- 1. GENERAL OUTLINE
- 2. Part Names and Function
- 3. SETUP
- 4. Configuring Printer Settings Using the Specialized Utility
- 5. Configuring Ethernet Network Settings Using Network Seeker
- 6. Configuring Printer Settings Using a Browser
- 7. Configuring the Printer Using the Operation Panel
- 8. Online Configuration Mode
- 9. Clearing Jobs Stored in the Printer
- 10. Maintenance
- 11. Appendices
53
——
1. Turn off the power to the printer and host computer.
2. Insert the cable into the appropriate interface port at the back of the printer.
Tighten any locking screws to secure the cable.
USB cable
LAN cable
Serial cabl
e
3. Insert the other end of the cable into the appropriate interface port in the host com-
puter.
Tighten any locking screws to secure the cable.
Using an Ethernet connection
Congure network settings as necessary.
Refer to 5. Conguring Ethernet Network Settings Using Network Seeker
CAUTION
To check the current Ethernet settings, press the Ethernet panel button located next to the
Ethernet interface to printout the settings.
To initialize Ethernet settings, press and hold the Ethernet panel button for at least 3 seconds.
Once the buzzer emits a short tone, press and hold the Ethernet panel button again within 3
seconds for at least 3 seconds.