User Manual
Table Of Contents
- WEEE MARK
- Compliance Statement for European Users
- GENERAL PRECAUTIONS
- SAFETY PRECAUTIONS...WHICH SHOULD BE STRICTLY OBSERVED
- Warnings
- General Precautions
- Installation Precautions
- PRECAUTIONS IN HANDLING THE PRINTER
- THE TABLE OF CONTENTS
- 1. GENERAL OUTLINE
- 2. Part Names and Function
- 3. SETUP
- 4. Configuring Printer Settings Using the Specialized Utility
- 5. Configuring Ethernet Network Settings Using Network Seeker
- 6. Configuring Printer Settings Using a Browser
- 7. Configuring the Printer Using the Operation Panel
- 8. Online Configuration Mode
- 9. Clearing Jobs Stored in the Printer
- 10. Maintenance
- 11. Appendices
70
——
7. Conguring the Printer Using the
Operation Panel
The following operations can be performed from the control panel after changing the
printer operation mode to the special mode.
Adjust media sensors
Print test samples
Print the settings conguration
Change emulation modes
HEX dump mode
Initialize the printer
*This device is not equipped with the [Menu Conguration Mode] featured in other
models.
1. With the top cover closed, turn on the power to the printer while pressing and holding
the FEED key.
The printer changes to the special mode.
The buzzer emits 3 short tones and the status LED ashes alternately in green and red.
2. Press the FEED key to select the desired operation mode.
Mode Buzzer Status LED
Color Interval
Special function mode 3 short tones Alternately in green and
red
Flashes quickly
Press the FEED key ↓
Sensor Adjustment Mode 1 short tones Green Flashes
Press the FEED key ↓
Test print mode 2 short tones Green Flashes quickly
Press the FEED key ↓
Conguration print mode 3 short tones Amber Flashes
Press the FEED key ↓