User Manual
Table Of Contents
- WEEE MARK
- Compliance Statement for European Users
- GENERAL PRECAUTIONS
- SAFETY PRECAUTIONS...WHICH SHOULD BE STRICTLY OBSERVED
- Warnings
- General Precautions
- Installation Precautions
- PRECAUTIONS IN HANDLING THE PRINTER
- THE TABLE OF CONTENTS
- 1. GENERAL OUTLINE
- 2. Part Names and Function
- 3. SETUP
- 4. Configuring Printer Settings Using the Specialized Utility
- 5. Configuring Ethernet Network Settings Using Network Seeker
- 6. Configuring Printer Settings Using a Browser
- 7. Configuring the Printer Using the Operation Panel
- 8. Online Configuration Mode
- 9. Clearing Jobs Stored in the Printer
- 10. Maintenance
- 11. Appendices
78
——
5. Press the FEED key to select an emulation switching mode.
Each press of the FEED key cycles through the emulation mode options of DMX mode, ZPL
mode, and EPL mode.
Emulation mode Buzzer Status LED
Color Interval
DMX mode 1 short tones Green Flashes
Press the FEED key ↓
ZPL mode 2 short tones Green Flashes quickly
Press the FEED key ↓
EPL mode 3 short tones Amber Flashes
Press the FEED key↓
Returns to DMX mode.
6. Press and hold the FEED key for at least 3 seconds.
7. Release the FEED key once the buzzer emits a long tone and then press the FEED key
again.
The selected emulation mode is set, and the printer restarts.
To cancel setting the emulation mode, continue pressing and holding the FEED key for
at least 3 seconds without releasing your nger at step 7.
The buzzer emits 4 short tones, and the printer restarts.
7.5 HEX Dump Mode
This mode is used to print a hex dump list (data received by the printer represented in
hex values) for conrmation of the data content.
Example of dump list printing
Load media and then perform the following procedure.
1. Turn on the power to the printer while pressing and holding the FEED key to start the
printer in special function mode.