User Manual
Table Of Contents
- WEEE MARK
- Compliance Statement for European Users
- GENERAL PRECAUTIONS
- SAFETY PRECAUTIONS...WHICH SHOULD BE STRICTLY OBSERVED
- Warnings
- General Precautions
- Installation Precautions
- PRECAUTIONS IN HANDLING THE PRINTER
- THE TABLE OF CONTENTS
- 1. GENERAL OUTLINE
- 2. Part Names and Function
- 3. SETUP
- 4. Configuring Printer Settings Using the Specialized Utility
- 5. Configuring Ethernet Network Settings Using Network Seeker
- 6. Configuring Printer Settings Using a Browser
- 7. Configuring the Printer Using the Operation Panel
- 8. Online Configuration Mode
- 9. Clearing Jobs Stored in the Printer
- 10. Maintenance
- 11. Appendices
98
——
HTTP Server
The Web monitoring function can be used to congure printer and network settings.
Refer to the pages describing the Web monitor for more information.
Refer to 6. Conguring Printer Settings Using a Browser
Port No. 80
Max. simultaneous connections 4
HTTP version HTTP/1.1
DHCP
Automatically retrieves IP address information from a DHCP server within 60 seconds
after the power is turned on.
If IP address information cannot be retrieved automatically, a xed IP address (default
is 169.254.1.10) is applied.
SNMP Agent
SNMP Version SNMPv2 (Trap function not supported)
Port No. 161
Supported MIBs HOST-RESOURCES-MIB and Citizen-MIB (Private)
Community name public
Connector Connections
Pin No. Signal Function
1 TX+ Transmit (positive)
2 TX- Transmit (negative)
3 RX+ Receive (positive)
4 N.C. -
5 N.C. -
6 RX- Receive (negative)
7 N.C. -
8 N.C. -
Compatible connectors
Printer: RJ-45 connector
LED operation
The following table describes port LED operation.
12
1. Network communication speed indicator
Communication speed LED (Green)
100 Mbps On
10 Mbps/disconnected Flashes