Instruction manual

Chapter 2 Installation, Configuration and Management

2-82 NetScaler 9000 Series Installation and Configuration Guide - Volume 1

NSICG60_DEC04

z To disable the Load Balancing feature, type the following CLI command:

disable feature lb

Note:

1. If the license key is not available for a particular feature then the

enable feature command does not enable the feature. The

NetScaler 9000 system displays an error message:

ERROR:

feature(s) not licensed

2. If multiple features are enabled at the same time, for example,

enable feature lb cs cf and one of the feature does not

have the license key, then the enable feature command will

display an error for that feature.

2.8.2 Commands for the features that are enabled or disabled

Irrespective of whether a feature is enabled or disabled, you can use both the

CLI and GUI to configure the licensed features. The feature configuration

succeeds irrespective of whether the feature is enabled or disabled.

Note: When a feature is temporarily disabled and if you try to configure this

feature using the CLI or GUI, the configuration succeeds.

The feature enabled or disabled check is done at runtime by NetScaler during

it's normal operation and depending on whether a feature is enabled or

disabled the appropriate feature specific run time behavior is enforced. The

following section clarifies the run time behavior of each feature when the

feature is disabled.

Note: The system displays warning message when the user tries to

configure a disabled feature. The feature names are acronyms, as used

in the

enable feature command.

The warning message is used to notify the user that, although the

requested configuration action has been made, the corresponding

feature is not currently enabled; the command will have no effect on

the runtime behavior of the NetScaler 9000 system until the feature is

enabled.