Instruction manual

Chapter 3: High Availability
NetScaler 9000 Series Installation and Configuration Guide - Volume 1 3-5
NSICG60_JAN05
3.2.2.1 Adding or changing the Mapped IP address using Telnet or
SSH
 Telnet/SSH access to both the NetScaler 9000 systems
Use this procedure if you have Telnet access and/or SSH access only to
both the NetScaler 9000 systems:
1. Enter the
ns config CLI command on the first NetScaler 9000
systems.
2. The configuration menu is displayed. In the menu use the menu item
4 to change the mapped IP address.
Note: Do not add server, services and other configurations while changing
the NetScaler 9000 system’s basic configuration using the ns
config command.
3. In the configuration menu, use menu item 6 to save changes and exit.
4. Repeat steps 1 to 3 for the second NetScaler 9000 system.
5. Reboot both NetScaler 9000 systems.
 Telnet/SSH Access to One of the NetScaler 9000 system
Use this procedure if you have Telnet access and/or SSH access only to
one of the two NetScaler 9000 systems:
1. Telnet to the NetScaler 9000 system’s IP address of one of the
NetScaler 9000 systems.
2. Enter the ns config CLI command on this NetScaler 9000
system.
3. The configuration menu is displayed. In the menu, use the menu item
4 to change the mapped IP address.
Note: (Do not add server, services and other configurations while changing
the NetScaler 9000 system’s basic configuration using the config
ns command.)
4. In the configuration menu, use menu item 6 to save changes and exit.
5. On the reboot message - do not reboot.