Instruction manual

Chapter 3: High Availability
3-6 NetScaler 9000 Series Installation and Configuration Guide - Volume 1
NSICG60_JAN05
6. Telnet from this NetScaler 9000 system to the other NetScaler 9000
system.
7. Repeat steps 2 to 4 for the second NetScaler 9000 system.
8. Reboot the second NetScaler 9000 system.
Note: This disconnects the Telnet session to the other NetScaler 9000
system and you will be returned (still logged in) to the first NetScaler
9000 system.
9. Reboot the first NetScaler 9000 system.
3.3 Configuring two NetScaler 9000 systems in High
Availability Mode
This section describes the configuration steps to connect two NetScaler 9000
systems in High availability Mode as shown in Figure 3-2
With these configuration steps you can configure the one NetScaler 9000
system as Primary and the other NetScaler 9000 system as Secondary.
Figure 3-2 NetScaler 9000 system Connected in the High Availability Mode
3.3.1 Pre-configuration Steps
1. Perform the steps mentioned in the section Considerations for High
Availability Setup.
2. Disconnect the NetScaler 9000 systems from the switches.