Instruction manual

Chapter 3: High Availability
3-8 NetScaler 9000 Series Installation and Configuration Guide - Volume 1
NSICG60_JAN05
l <ifnum>, is the number of the interface to be disabled in the
NetScaler 9000 system (NS1).
Note: Repeat step 5 for each NetScaler 9000 system interface that will not
be used.
6. To disable monitoring for those interfaces whose failure should not cause
a failover in the HA mode, enter the following command in the CLI.
set interface <ifnum> -hamonitor OFF
where
l ifnum is the number of a NetScaler 9000 system interface in the
NetScaler 9000 system (NS1).
Note: Repeat step 6 for each NetScaler 9000 system interface that will be
used and whose failure should not cause fail over.
7. To save the configuration enter
save config in the CLI.
8. Connect the first NetScaler 9000 system (NS1)to the switches.
3.3.2.2 Configuring Second NetScaler 9000 system (NS2)
1. Log-in to the NetScaler 9000 system using your Username and Password
on the second NetScaler 9000 system.
Note: If the NetScaler 9000 system is not pre-configured then you must
define the system configuration by entering the
/netscaler/
nsconfig command at the shell prompt.
2. If you want to modify the present system IP address type
ns config on
the Command Line Interface (CLI)
—Or—
If you want to continue with the pre configured system IP address then
jump to Step 4.
3. At the reboot prompt, type
yes.
4. Enter the following command in the CLI.
add node <id> <ipAddress>