Instruction manual

Chapter 3: High Availability
NetScaler 9000 Series Installation and Configuration Guide - Volume 1 3-9
NSICG60_JAN05
where in the
l id: specify the unique node number for the first NetScaler 9000
system (NS1).
l ipAddress: specify the IP address of the first NetScaler 9000 system
(NS1).
For the example shown in Figure 3-2 on page 6, specify the Node ID as
2
and the IP address as
10.102.1.1.
Note: The maximum node ID for NetScaler 9000 systems in a high
availability setup is 64.
5. To disable those interfaces in the NetScaler 9000 system that are not
connected or not being used for traffic, enter the following CLI
command:
disable interface <ifnum>
where
l <ifnum>, is the number of the interface to be disabled in the
NetScaler 9000 system (NS2).
Note: Repeat step 5 for each NetScaler 9000 system interface that will not
be used.
6. To disable monitoring for those interfaces whose failure should not cause
a failover in the HA mode, enter the following command in the CLI.
set interface <ifnum> -hamonitor OFF
where
l ifnum is the number of the interface to be disabled in the NetScaler
9000 system (NS2).
Note: Repeat step 6 for each NetScaler 9000 system interface that will be
used and whose failure should not cause fail over.
7. To save the configuration enter
save config in the CLI.
8. Connect the second NetScaler 9000 system (NS2) to the switches.