Instruction manual

Chapter 3: High Availability
NetScaler 9000 Series Installation and Configuration Guide - Volume 1 3-13
NSICG60_JAN05
where
z <ifnum>, is the number of the interface to be disabled in the
second NetScaler 9000 system (NS2).
Note: Repeat step 5 for each NetScaler 9000 system interface that will not
be used.
8. To disable monitoring for those interfaces whose failure should not cause
a failover in the HA mode, enter the following command in the CLI.
set interface <ifnum> -hamonitor OFF
where
l ifnum is the number of a NetScaler 9000 system interface in the
second NetScaler 9000 system (NS2).
Note: Repeat step 6 for each NetScaler 9000 system interface that will be
used and whose failure should not cause fail over.
9. To save the configuration enter
save config in the CLI.
10. Connect the second NetScaler 9000 system (NS2) to the network
11. Verify the configuration using the
show node command:
Note: Verify the status of the synchronization process by typing the show
node command after a few seconds. If the “Success: Synchronization
succeeded” message is displayed, perform the next step.
12. To make the HA status of NS2 node active, use the following CLI
command:
set node -hastatus ENABLE
13. Execute the
save config command.
3.5 Verifying Configuration Propagation
In a correct setup any command issued on primary NetScaler 9000 system
NS1 must propagate automatically to secondary NetScaler 9000 system NS2.