Instruction manual

REPRODUCED OR TRANSMITTED IN ANY FORM OR BY ANY MEANS OR USED TO MAKE DERIVATIVE

WORK (SUCH AS TRANSLATION, TRANSFORMATION, OR ADAPTATION) WITHOUT THE EXPRESS

WRITTEN PERMISSION OF NETSCALER, INC.

ALTHOUGH THE MATERIAL PRESENTED IN THIS DOCUMENT IS BELIEVED TO BE ACCURATE, IT IS

PRESENTED WITHOUT WARRANTY OF ANY KIND, EXPRESS OR IMPLIED. USERS MUST TAKE ALL

RESPONSIBILITY FOR THE USE OR APPLICATION OF THE PRODUCT(S) DESCRIBED IN THIS MANUAL.

NETSCALER, INC. OR ITS SUPPLIERS DO NOT ASSUME ANY LIABILITY THAT MAY OCCUR DUE TO

THE USE OR APPLICATION OF THE PRODUCT(S) DESCRIBED IN THIS DOCUMENT. INFORMATION IN

THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. COMPANIES, NAMES, AND DATA USED

IN EXAMPLES ARE FICTITIOUS UNLESS OTHERWISE NOTED.

The following information is for FCC compliance of Class A devices: This equipment has been tested and found to comply

with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide

reasonable protection against harmful interference when the equipment is operated in a commercial environment. This

equipment generates, uses, and can radiate radio-frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential

area is likely to cause harmful interference, in which case users will be required to correct the interference at their own

expense.

Modifying the equipment without NetScaler’s written authorization may result in the equipment no longer complying with

FCC requirements for Class A digital devices. In that event, your right to use the equipment may be limited by FCC

regulations, and you may be required to correct any interference to radio or television communications at your own expense.

You can determine whether your equipment is causing interference by turning it off. If the interference stops, it was probably

caused by the NetScaler Request Switch™ 9000 Series equipment. If the NetScaler equipment causes interference, try to

correct the interference by using one or more of the following measures:

•Move the NetScaler equipment to one side or the other of your equipment.

•Move the NetScaler equipment farther away from your equipment.

•Plug the NetScaler equipment into an outlet on a different circuit from your equipment. (Make sure the NetScaler

equipment and your equipment are on circuits controlled by different circuit breakers or fuses.)

Modifications to this product not authorized by NetScaler, Inc., could void the FCC approval and negate your authority to

operate the product.

BroadCom is a registered trademark of BroadCom Corporation. Fast Ramp, NetScaler, and NetScaler Request Switch are

trademarks of NetScaler, Inc. Linux is a registered trademark of Linus Torvalds. Internet Explorer, Microsoft, PowerPoint,

Windows and Windows product names such as Windows NT are trademarks or registered trademarks of the Microsoft

Corporation. NetScape is a registered trademark of Netscape Communications Corporation. Red Hat is a trademark of Red

Hat, Inc. Sun and Sun Microsystems are registered trademarks of Sun Microsystems, Inc. Other brand and product names

may be registered trademarks or trademarks of their respective holders.

Software covered by the following third party copyrights may be included with this product and will also be subject to the