Instruction manual

Chapter 2 Installation, Configuration and Management
NetScaler 9000 Series Installation and Configuration Guide - Volume 1 2-3
NSICG60_DEC04
b. One 10/100/1000Base-T network interface (labeled 0/1)
c. Serial Console (9600 baud, 8 bits, 1 stop bit, No parity)
 LEDs
When the LEDs on the NetScaler 9800-SX are lit, they indicate the
following:
l LED labeled 1000: The corresponding port has been established for
1000Base-SX.
l LED labeled ACT: The corresponding port is active (receiving or
transmitting traffic).
2.1.3 NetScaler 9800-T
The NetScaler 9800-T is a 2U unit that supports copper Gigabit Ethernet and
has two GB of memory. Figure 2-3 shows this model.
Figure 2-3 NetScaler 9800-T System
 Ports
The NetScaler 9800-T unit has the following ports:
l Four 10/100/1000Base-T network interfaces (labeled 1/1, 1/2, 1/
3, and 1/4)
l One 10/100/1000Base-T network interface (labeled 0/1)
l Serial Console (9600 baud, 8 bits, 1 stop bit, No parity)
 LEDs
When the LEDs on the NetScaler 9800-T are lit, they indicate the
following:
l LED labeled 1000: The corresponding port has been established for
1000Base-T.