Instruction manual

Chapter 2 Installation, Configuration and Management
NetScaler 9000 Series Installation and Configuration Guide - Volume 1 2-5
NSICG60_DEC04
2.2.2 NetScaler 9000 system LCD Back Light
z The NetScaler 9000 system LCD has a neon backlight that starts blinking
when there is an active alert. If the display information is more than one
screen then it blinks at the beginning of each display screen.
z When the Product Name (short) system shuts down the backlight remains
ON exactly for one minute and then automatically turns OFF.
z If the LCD displays OUT OF SERVICE message, this indicates that the
Product Name (short) system has been stopped (with or without errors).
2.2.3 Display Information
The display information on the Product Name (short) system LCD can be
divided into two categories:
z Special Display Screens: this information is displayed for very specific
scenarios.
z Regular Display Screens: this information is displayed when the Product
Name (short) system is in active mode.
Note: By default, the refresh rate of the screen is 3 seconds and this value
can be reconfigured using the Product Name (short) system’s LCD
Program Options. Refer to “NSLCD program options” on page 12 for
more information.
2.2.4 Special Display Screens
 Power Up screen
This screen is displayed immediately after the Product Name (short)
system is switched ON.
Figure 2-5 Power-on display in LCD
1 The first line in the display shows the company name.