Instruction manual

Chapter 2 Installation, Configuration and Management
NetScaler 9000 Series Installation and Configuration Guide - Volume 1 2-7
NSICG60_DEC04
Figure 2-7 Out of Service display in LCD
1 The first line displays the message.
2 The second line displays the IP address of the NetScaler 9000 system
that has stopped.
Note: If the “Out of Service” error message is not displayed on the
NetScaler 9000 system LCD, check the NetScaler 9000 system
console for more information on why NetScaler 9000 system is not
functioning.
2.2.5 Regular Display Screens
 Configuration Screen
The NetScaler 9000 system LCD displays this configuration information
as shown in the following figure:
Figure 2-8 Configuration display in LCD
1 The first line displays:
a. The NetScaler 9000 system status as:
z Pri: Indicates that the NetScaler 9000 system box is in
Stand-alone mode or indicates that the NetScaler 9000 system is
the Primary node in a High Availability pair.
—Or—
z Sec: Indicates that the NetScaler 9000 system is the Secondary
node in a High Availability pair.
b. The system uptime of the NetScaler 9000 unit in the
HH:MM
format.