Instruction manual

Chapter 2 Installation, Configuration and Management
2-10 NetScaler 9000 Series Installation and Configuration Guide - Volume 1
NSICG60_DEC04
Note: The NetScaler 9400 system has only two ports 1/1 and 1/2 and
hence uses only second and third space to display the port’s
information.
1 First Quadrant (displayed in the Top Left corner as symbol
S)
This quadrant shows the port speed information. The speed displayed
is encoded in special symbols as shown in the following figure:
Figure 2-14 First Quadrant: Port Speed Information
2 Second Quadrant (displayed in the Bottom Left corner as symbol D)
This quadrant displays the port duplex information. The duplex status
displayed is encoded in special symbols as shown in the following
figure:
Figure 2-15 Second Quadrant: Port Duplex Information
3 Third Quadrant (displayed in the Top Right corner as symbol F)
Link is down,
no speed info
is available
Speed is 1000
Mbits/s (Gigabit
Ethernet)
Speed is 10
Mbits/s (plain
Ethernet)
Speed is 100
Mbits/s (Fast
Ethernet)
Link is down,
no duplex
info is
available
Autosense half
duplex mode
with Auto
duplex
requested -
possible error
conditions
Full duplex
mode
Half duplex
mode with Half
duplex
requested