Instruction manual

Chapter 2 Installation, Configuration and Management
NetScaler 9000 Series Installation and Configuration Guide - Volume 1 2-11
NSICG60_DEC04
This quadrant displays the port flow control information. The flow
control status displayed is encoded in special symbols as shown in the
following figure:
Figure 2-16 Third Quadrant: Port Flow Control Information
4 Fourth quadrant (displayed in the Bottom Right corner as symbol R)
This quadrant displays the PORT Receive (Rx) statistics and PORT
Enable state. These statistics are encoded in special symbols as shown
in the following figure:
Figure 2-17 Fourth Quadrant: Port Receive Statistics Information
For example
The NetScaler 9400 system LCD screen with two interfaces 1/1 and 1/2 is
shown below. Both the interfaces are in 100 Mbit / Half Duplex / No Flow
Control / Rx Idle mode.
Link is down, no
flow control info
is available
No flow
control
Tx only flow
control
Rxd
only flow
control
Rx/Tx flow
control
PORT is
disabled (see
link status in
other
quadrants)
Link is down
and PORT is
enabled -
alert state
Rx of 50%
of line
speed
Rx of
100% of
line speed
Rx less
then few
percent
of line
speed