Instruction manual

Chapter 2 Installation, Configuration and Management
2-12 NetScaler 9000 Series Installation and Configuration Guide - Volume 1
NSICG60_DEC04
2.2.6 NSLCD program options
The NetScaler 9000 system LCD (NSLCD) program has the following
program options available will help you to control the information displayed.
Note: The NetScaler 9000 system startup script uses appropriate options
hence customizing the options may be used for very specific
requirements.
Table 2-1 List of NSLCD Commands
Option Description NSLCD command
-k Starts the NSLCD in
background for
NetScaler 9000 system
status monitoring
/netscaler/nslcd -k
-h Displays the help screen /netscaler/nslcd -h
-t SEC Sets the refresh rate time
in seconds.
Default refresh rate is 3
seconds.
/netscaler/nslcd -t SEC
-b MIN Sets the back light
time-out in minutes
Default value for the
back light timeout is 1
minute
/netscaler/nslcd -b MIN
-S Enables serial
communications.
/netscaler/nslcd -S
-A Enables alternate device.
This option must be used
with -Q option.
/netscaler/nslcd -A
Speed and
Flow Control
state
Duplex and Rx
state