Instruction manual

Chapter 2 Installation, Configuration and Management
NetScaler 9000 Series Installation and Configuration Guide - Volume 1 2-19
NSICG60_DEC04
4. One or two AC power cable(s)
5. Two RJ-45-to-DB-9 adapters
6. RJ-45-to-DB-25 adapter
7. Packet of screws
8. Ethernet cables (not supplied)
9. One or two power outlets
10. Rack space
11. Free switch ports to connect to the NetScaler 9000 system
2.3.2.2 Software
1. IP addresses
z One or two NetScaler IP addresses [NSIP] (In HA mode you
require two unique NetScaler IP addresses)]
z Appropriate password choices for the root, nsmaint, and
nsroot account. As part of the deployment process, these three
account passwords must be changed.
Note: In HA mode, when you change the password of the nsroot user
account, make sure you change it to the same password on both
nodes of the HA pair as password synchronization is required.
z Mapped IP[MIP]
z IP address for the NetScaler 9000 system’s default router
z Additional subnet/VLAN IP addresses as needed
2. Additional IP address(s) for any virtual servers (VIPs) that needs to be
configured
Note: The NetScaler 9000 system supports any combination of 5000 virtual
servers and configured services.
3. For SNMP access to NetScaler 9000 system, you must have
z One Community Name
z IP address of management station