Instruction manual

Chapter 2 Installation, Configuration and Management
NetScaler 9000 Series Installation and Configuration Guide - Volume 1 2-23
NSICG60_DEC04
Note: Make sure not to create a network loop — this results if you connect
the cable in step 3a and the cable in step 3b to the same switch.
In case when current configuration requires less than five ports then
any of five available ports could be used (based on Ethernet
technology used). It is good idea to DISABLE all unused ports
through software (it is mandatory for HA configuration).
Figure 2-23 Front panel of NetScaler 9800-SX
Figure 2-24 Front of NetScaler 9000 system NetScaler 9800-T
4. Connect a terminal (which can be a computer supporting VT100 terminal
emulation) to the console port on the front of the unit.