Instruction manual

Chapter 2 Installation, Configuration and Management
NetScaler 9000 Series Installation and Configuration Guide - Volume 1 2-25
NSICG60_DEC04
The green LED above the switch lights and stays lit.
Note: After the initial power-on, turn power off only, as described in the
Powering-Off the NetScaler 9000 system on Page ’44’ in this chapter.
2.3.5 Installation Tips
z If you are setting up the NetScaler 9000 system for the first time, follow
the steps given in “Initial Configuration of NetScaler 9000 System” on
page 27 of this chapter.
z If you are reconfiguring the NetScaler 9000 system, follow the steps
given in the “Reconfiguring the NetScaler 9000 system” on page 43 of
this chapter.
2.4 Configuring the NetScaler 9000 System
Use the console to configure the NetScaler 9000 system using its command
line interface (CLI). You can access the CLI using a serial port or Telnet. If
you want to use secure communications, you can access the CLI using Secure
Shell (SSH).
You can also use the NetScaler 9000 system’s GUI to configure the NetScaler
9000 system. The NetScaler 9000 system’s GUI is a Java applet that runs
within a web browser. Details about accessing the CLI and GUI are provided
later in this chapter.
Figure 2-26 provides an overview of the process you will be following to
configure the NetScaler 9000 system.