Instruction manual

Chapter 2 Installation, Configuration and Management
2-28 NetScaler 9000 Series Installation and Configuration Guide - Volume 1
NSICG60_DEC04
The interface settings displayed in the Requested row above should
match with the port settings on the switch.
2. Starting the Configuration Program
After the NetScaler 9000 system is powered-on, a login prompt is
displayed on the terminal attached to the NetScaler 9000 system.
l From the command prompt, login to the nsroot (initial password
for this account is nsroot).
l The NetScaler 9000 system’s configuration program starts.
The following is displayed:
The NetScaler 9000 system has not been configured.
As you enter values for each configuration parameter, the
program automatically displays the next screen.
Follow the instructions in each screen.
Note: A value within brackets ([]) indicates the current value that has
been set for that parameter. Empty brackets do not have a value set
but will show the value after it has been set.
3. Specifying the NetScaler 9000 system’s IP Address
This configuration parameter identifies the NetScaler 9000 system in the
network and is used to access the system for management purposes.
Enter a unique IP address chosen for this NetScaler 9000 system when the
following is displayed:
NetScaler 9000 system’s IP Address
----------------------
This specifies the NetScaler 9000 system’s IP address.
Enter the NetScaler 9000 system’s IP address []: