Instruction manual

Chapter 2 Installation, Configuration and Management
NetScaler 9000 Series Installation and Configuration Guide - Volume 1 2-29
NSICG60_DEC04
4. Specifying the Netmask
This configuration parameter is the netmask for the subnet (network section)
into which the NetScaler 9000 system is being installed (for example,
255.255.0.0).
Enter the netmask when the following is displayed:
Netmask
-------
This specifies the netmask for the network in which the
NetScaler 9000 system is being installed.
Enter the netmask [0.0.0.0]:
5. Specifying Routes
In the configuration parameter, specify the IP address of the default router
to which the NetScaler 9000 system sends packets.
Enter the default router’s IP address when the following message is
displayed:
Default Router IP Address
-------------------------
This specifies the IP address of the default router where
packets must be sent by the NetScaler 9000 system if the
destination IP address does not belong to the local
network.
Enter the IP address of the default router []:
After the default router is set, the following message is displayed:
Do you want to specify additional routes? [NO]:
l If you do not want to make any more changes to the NetScaler 9000
system’s routing table, enter NO and then proceed to the “Specifying
the NetScaler 9000 system’s Mapped IP Address” on page 32.
—OR—
l Enter YES and proceed to next section: Adding More Routes.
 Adding More Routes
The following information is displayed.