Instruction manual

Chapter 2 Installation, Configuration and Management
2-30 NetScaler 9000 Series Installation and Configuration Guide - Volume 1
NSICG60_DEC04
Note: The settings in the following routing table are examples that were
entered as the default router IP address parameter in the previous
configuration steps.
STATIC ROUTES MENU
------------------
This menu allows you to add, modify or remove entries from
the NetScaler's static routing table, which is shown
below. Note:
- The default router must be specified.
- To apply default router changes, the system must be
rebooted.
- Each network can have only one entry in the table.
- Routes to multicast addresses are not supported.
NetScaler 9000 system ROUTING TABLE
Network Netmask Gateway
--------------------
default 0.0.0.0 10.101.0.1
----------------------------------------
1. Add static routes.
2. Remove static routes.
3. Remove all static routes.
4. Return to the previous menu.
Select a menu item from 1 to 4 [4]:
Enter 1 to display the following:
Add or Modify Routing Table Entries
-----------------------------------
Enter the routes in the format:
'network:[netmask]:gateway', where 'network' is the IP
address of the network where traffic will be routed,
'netmask' will be applied to a destination IP address to
determine out the network address belongs to (this is an
optional value), and 'gateway' is the IP address of the
gateway where traffic will be directed.