Instruction manual

Chapter 2 Installation, Configuration and Management
NetScaler 9000 Series Installation and Configuration Guide - Volume 1 2-31
NSICG60_DEC04
If you enter the word 'default' as the value for
'network', then this defines the default router. Separate
route entries by a comma. For example:
default::xxx.xxx.xxx.xxx,
yyy.yyy.yyy.0:255.255.255.0:zzz.zzz.zzz.zzz
Enter the static routes to be added:
Next, follow these steps:
1 Enter the new route or routes according to the instructions on the
screen.
Make sure to separate each IP address by typing a colon (:) between
them. Each route entry must be separated by a comma.
For example:
230.10.10.1,130.40.0.0:255.255.0.0:130.40.1.1
After you press the <Enter> key, the Static Routes Menu is
displayed.
2 Enter the number 4 to quit.
3 If you are doing initial NetScaler 9000 system configuration, proceed
to “Specifying the NetScaler 9000 system’s Mapped IP Address” on
page 32.
 Removing or Changing Static Routes
You can change, remove or add new routes to the NetScaler 9000
system’s routing table.
You can remove one, some or all of the static routes from the NetScaler
9000 system’s routing table.
To remove static routes:
1 Go to the STATIC ROUTES MENU :
a. To remove one or some routes, enter 2. Next, enter the routes to
be removed. Follow the instruction displayed on the screen.
OR
b. To remove all routes, enter 3 and follow the instructions
displayed on the screen.
2 Enter 4 to quit and return to the STATIC ROUTES MENU.
3 If you are performing initial NetScaler 9000 system configuration,
proceed to the next configuration step.