Instruction manual

Chapter 2 Installation, Configuration and Management
2-34 NetScaler 9000 Series Installation and Configuration Guide - Volume 1
NSICG60_DEC04
The NetScaler system has the primary administrative user’s (nsroot) password
set as ‘nsroot’. For security reasons, it is essential to change the default
password.
The following is displayed:
Administrator's (nsroot) password
-------------------------------
This assigns the Administrator's (nsroot) password
Changing local password for nsroot.
New password:
Enter new password and press Enter key. Then follow the messages to
confirm the new password.
Note: If you are configuring the NetScaler 9000 system in High Availability
mode, the password for the
nsroot account must be the same on
both NetScaler systems.
10. Reviewing the Parameters
Once the initial parameters are set, the menu below appears, allowing you
the opportunity to review the parameters that you have set and make
further changes if needed. The value that appears within the brackets (
[])
indicates the currently set value for that parameter.
REVIEW CONFIGURATION PARAMETERS MENU
------------------------------------
This menu allows you to view and/or modify the
NetScaler's configuration. Each configuration parameter
displays its current value within brackets if it has been
set. To change a value, enter the number that is displayed
next to it.
------------------------------------
1. NetScaler's IP address: [192.168.100.20]
2. Netmask: [255.255.255.0]
3. Default router and static routes.
4. Mapped IP address: [192.168.100.21]
5. Netmask for mapped IP address: [255.255.255.0]