Instruction manual

Chapter 2 Installation, Configuration and Management
2-38 NetScaler 9000 Series Installation and Configuration Guide - Volume 1
NSICG60_DEC04
To specify this optional parameter, use the -maxReq argument of the
set config CLI command.
2.4.2.1 Configuration Procedure for Optional Parameters
(Using the CLI)
To configure these optional parameters using the CLI, proceed as follows:
1. Use the set config command at the CLI command prompt.
Example:
set config -httpPort 80 -cip ENABLE clientIP -maxReq
1000 -maxConn 500 –cookieversion 0
2. Save your changes by entering the save config command at the >
CLI command prompt.
The show config CLI command displays all the settings that have
been configured with the set config CLI command.
Note: For more information on the reboot procedure, refer to “Restarting
the NetScaler 9000 system” on page 43.
2.4.3 Post-Configuration Checklists
Complete the following checklists after you finish the NetScaler 9000 system
configuration:
NetScaler 9000 system CONFIGURATION CHECKLIST
The build suggested by NetScaler 9000 system staff is running.
NetScaler 9000 system Build Number: ____________________
If upgrading from a previous build, there are no incompatibility issues.
(Incompatibility issues are documented in the build’s release notes.)